Uniden Pro 710E
-
- WWPDX MEMBER
- Posts: 96
- Joined: Mon Dec 09, 2013 8:34 pm
Uniden Pro 710E
Anyone know any cap changes for RX on a Uniden Pro 710E?
- Goldfinger
- Site Maintenance
- Posts: 3849
- Joined: Sat Jun 30, 2007 12:27 am
- Location: Beaver State
Transmit:
C85, C52: Change to a 1 or 2.2uF, 25 volt or higher mylar, polyester or non-polarized electrolytic
Receive:
C23, C25, C54: Change to a 1 or 2.2uF, 25 volt or higher mylar, polyester or non-polarized electrolytic
Receive and Transmit:
C51: Change to a 1 or 2.2uF, 25 volt or higher mylar, polyester or non-polarized electrolytic
C44: Change to a 1000uF, 25 volt electrolytic. Observe polarity
C85, C52: Change to a 1 or 2.2uF, 25 volt or higher mylar, polyester or non-polarized electrolytic
Receive:
C23, C25, C54: Change to a 1 or 2.2uF, 25 volt or higher mylar, polyester or non-polarized electrolytic
Receive and Transmit:
C51: Change to a 1 or 2.2uF, 25 volt or higher mylar, polyester or non-polarized electrolytic
C44: Change to a 1000uF, 25 volt electrolytic. Observe polarity
wwpdx
wwpdx.com
wwpdx.com
-
- WWPDX MEMBER
- Posts: 96
- Joined: Mon Dec 09, 2013 8:34 pm
-
- WWPDX MEMBER
- Posts: 96
- Joined: Mon Dec 09, 2013 8:34 pm
Welp, there are no markings on the board except for transistors and diodes. I tried to follow the schematics posted on cbtricks, but they show a different board number and it does not jive with what I have (PA-239AC). Also, what would cause the signal meter to read backwards when a modulated signal is received?